Total
500 CVE
| CVE | Vendors | Products | Updated | CVSS v2 | CVSS v3 |
|---|---|---|---|---|---|
| CVE-2024-50195 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: posix-clock: Fix missing timespec64 check in pc_clock_settime() As Andrew pointed out, it will make sense that the PTP core checked timespec64 struct's tv_sec and tv_nsec range before calling ptp->info->settime64(). As the man manual of clock_settime() said, if tp.tv_sec is negative or tp.tv_nsec is outside the range [0..999,999,999], it should return EINVAL, which include dynamic clocks which handles PTP clock, and the condition is consistent with timespec64_valid(). As Thomas suggested, timespec64_valid() only check the timespec is valid, but not ensure that the time is in a valid range, so check it ahead using timespec64_valid_strict() in pc_clock_settime() and return -EINVAL if not valid. There are some drivers that use tp->tv_sec and tp->tv_nsec directly to write registers without validity checks and assume that the higher layer has checked it, which is dangerous and will benefit from this, such as hclge_ptp_settime(), igb_ptp_settime_i210(), _rcar_gen4_ptp_settime(), and some drivers can remove the checks of itself. | |||||
| CVE-2024-50184 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: virtio_pmem: Check device status before requesting flush If a pmem device is in a bad status, the driver side could wait for host ack forever in virtio_pmem_flush(), causing the system to hang. So add a status check in the beginning of virtio_pmem_flush() to return early if the device is not activated. | |||||
| CVE-2024-47727 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 7.8 HIGH |
| In the Linux kernel, the following vulnerability has been resolved: x86/tdx: Fix "in-kernel MMIO" check TDX only supports kernel-initiated MMIO operations. The handle_mmio() function checks if the #VE exception occurred in the kernel and rejects the operation if it did not. However, userspace can deceive the kernel into performing MMIO on its behalf. For example, if userspace can point a syscall to an MMIO address, syscall does get_user() or put_user() on it, triggering MMIO #VE. The kernel will treat the #VE as in-kernel MMIO. Ensure that the target MMIO address is within the kernel before decoding instruction. | |||||
| CVE-2024-44235 | 1 Apple | 2 Ipados, Iphone Os | 2025-11-03 | N/A | 4.6 MEDIUM |
| The issue was addressed with improved checks. This issue is fixed in iOS 18.1 and iPadOS 18.1. An attacker may be able to view restricted content from the lock screen. | |||||
| CVE-2024-42284 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 7.8 HIGH |
| In the Linux kernel, the following vulnerability has been resolved: tipc: Return non-zero value from tipc_udp_addr2str() on error tipc_udp_addr2str() should return non-zero value if the UDP media address is invalid. Otherwise, a buffer overflow access can occur in tipc_media_addr_printf(). Fix this by returning 1 on an invalid UDP media address. | |||||
| CVE-2024-42224 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 6.1 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: net: dsa: mv88e6xxx: Correct check for empty list Since commit a3c53be55c95 ("net: dsa: mv88e6xxx: Support multiple MDIO busses") mv88e6xxx_default_mdio_bus() has checked that the return value of list_first_entry() is non-NULL. This appears to be intended to guard against the list chip->mdios being empty. However, it is not the correct check as the implementation of list_first_entry is not designed to return NULL for empty lists. Instead, use list_first_entry_or_null() which does return NULL if the list is empty. Flagged by Smatch. Compile tested only. | |||||
| CVE-2024-42160 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 7.8 HIGH |
| In the Linux kernel, the following vulnerability has been resolved: f2fs: check validation of fault attrs in f2fs_build_fault_attr() - It missed to check validation of fault attrs in parse_options(), let's fix to add check condition in f2fs_build_fault_attr(). - Use f2fs_build_fault_attr() in __sbi_store() to clean up code. | |||||
| CVE-2024-42159 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 7.8 HIGH |
| In the Linux kernel, the following vulnerability has been resolved: scsi: mpi3mr: Sanitise num_phys Information is stored in mr_sas_port->phy_mask, values larger then size of this field shouldn't be allowed. | |||||
| CVE-2024-42154 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 4.4 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: tcp_metrics: validate source addr length I don't see anything checking that TCP_METRICS_ATTR_SADDR_IPV4 is at least 4 bytes long, and the policy doesn't have an entry for this attribute at all (neither does it for IPv6 but v6 is manually validated). | |||||
| CVE-2024-40968 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: MIPS: Octeon: Add PCIe link status check The standard PCIe configuration read-write interface is used to access the configuration space of the peripheral PCIe devices of the mips processor after the PCIe link surprise down, it can generate kernel panic caused by "Data bus error". So it is necessary to add PCIe link status check for system protection. When the PCIe link is down or in training, assigning a value of 0 to the configuration address can prevent read-write behavior to the configuration space of peripheral PCIe devices, thereby preventing kernel panic. | |||||
| CVE-2024-40963 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: mips: bmips: BCM6358: make sure CBR is correctly set It was discovered that some device have CBR address set to 0 causing kernel panic when arch_sync_dma_for_cpu_all is called. This was notice in situation where the system is booted from TP1 and BMIPS_GET_CBR() returns 0 instead of a valid address and !!(read_c0_brcm_cmt_local() & (1 << 31)); not failing. The current check whether RAC flush should be disabled or not are not enough hence lets check if CBR is a valid address or not. | |||||
| CVE-2024-20506 | 1 Clamav | 1 Clamav | 2025-11-03 | N/A | 6.1 MEDIUM |
| A vulnerability in the ClamD service module of Clam AntiVirus (ClamAV) versions 1.4.0, 1.3.2 and prior versions, all 1.2.x versions, 1.0.6 and prior versions, all 0.105.x versions, all 0.104.x versions, and 0.103.11 and all prior versions could allow an authenticated, local attacker to corrupt critical system files. The vulnerability is due to allowing the ClamD process to write to its log file while privileged without checking if the logfile has been replaced with a symbolic link. An attacker could exploit this vulnerability if they replace the ClamD log file with a symlink to a critical system file and then find a way to restart the ClamD process. An exploit could allow the attacker to corrupt a critical system file by appending ClamD log messages after restart. | |||||
| CVE-2023-32726 | 1 Zabbix | 1 Zabbix-agent | 2025-11-03 | N/A | 3.9 LOW |
| The vulnerability is caused by improper check for check if RDLENGTH does not overflow the buffer in response from DNS server. | |||||
| CVE-2023-23931 | 1 Cryptography.io | 1 Cryptography | 2025-11-03 | N/A | 4.8 MEDIUM |
| cryptography is a package designed to expose cryptographic primitives and recipes to Python developers. In affected versions `Cipher.update_into` would accept Python objects which implement the buffer protocol, but provide only immutable buffers. This would allow immutable objects (such as `bytes`) to be mutated, thus violating fundamental rules of Python and resulting in corrupted output. This now correctly raises an exception. This issue has been present since `update_into` was originally introduced in cryptography 1.8. | |||||
| CVE-2025-24161 | 1 Apple | 6 Ipados, Iphone Os, Macos and 3 more | 2025-11-03 | N/A | 5.5 MEDIUM |
| The issue was addressed with improved checks. This issue is fixed in iPadOS 17.7.4, macOS Sonoma 14.7.3, visionOS 2.3, iOS 18.3 and iPadOS 18.3, macOS Sequoia 15.3, watchOS 11.3, tvOS 18.3. Parsing a file may lead to an unexpected app termination. | |||||
| CVE-2024-56778 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: drm/sti: avoid potential dereference of error pointers in sti_hqvdp_atomic_check The return value of drm_atomic_get_crtc_state() needs to be checked. To avoid use of error pointer 'crtc_state' in case of the failure. | |||||
| CVE-2024-56777 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: drm/sti: avoid potential dereference of error pointers in sti_gdp_atomic_check The return value of drm_atomic_get_crtc_state() needs to be checked. To avoid use of error pointer 'crtc_state' in case of the failure. | |||||
| CVE-2024-56776 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: drm/sti: avoid potential dereference of error pointers The return value of drm_atomic_get_crtc_state() needs to be checked. To avoid use of error pointer 'crtc_state' in case of the failure. | |||||
| CVE-2024-56728 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: octeontx2-pf: handle otx2_mbox_get_rsp errors in otx2_ethtool.c Add error pointer check after calling otx2_mbox_get_rsp(). | |||||
| CVE-2024-56725 | 1 Linux | 1 Linux Kernel | 2025-11-03 | N/A | 5.5 MEDIUM |
| In the Linux kernel, the following vulnerability has been resolved: octeontx2-pf: handle otx2_mbox_get_rsp errors in otx2_dcbnl.c Add error pointer check after calling otx2_mbox_get_rsp(). | |||||